Part C — Design, analysis & applications (50 pts) Problem 7 — Filter synthesis & Bode (20 pts) Design a second-order Butterworth low-pass filter with cutoff fc = 1 kHz using an active Sallen–Key topology with unity gain buffer. Use standard component values within a factor of two. a) (6 pts) Provide component values (R1, R2, C1, C2) and show normalized component selection for Butterworth (Q=0.707). b) (6 pts) Derive the transfer function H(s) and show the -3 dB cutoff condition. c) (8 pts) Sketch (or describe numerically) magnitude Bode plot points at 10 Hz, 100 Hz, 1 kHz, 10 kHz, and 100 kHz (provide gains in dB).
Problem 8 — Digital electronics & interfacing (15 pts) Given a microcontroller GPIO pin with output high 3.3 V (max source 20 mA) driving an LED requiring 10 mA at 2.0 V forward voltage. a) (5 pts) Calculate the resistor value and nearest standard 5% resistor to use. b) (5 pts) If the LED must be driven at 40 mA, propose a simple transistor driver (specify transistor type, resistor calculations, and protection). c) (5 pts) Explain briefly why direct MCU driving at 40 mA is discouraged. electrical engineering fundamentals by vincent del toro pdf
Problem 3 — AC steady-state & phasors (18 pts) Given: Vs = 10∠0° V, series network: R=50 Ω, L=100 mH, C=10 μF, frequency f=1 kHz. a) (6 pts) Convert L and C to reactances; compute total impedance Z and current phasor I. b) (6 pts) Compute voltage phasors across each element and verify KVL. c) (6 pts) Compute real power delivered by the source and reactive power. Part C — Design, analysis & applications (50
Problem 6 — Three-phase & power (12 pts) A balanced Y-connected load: Z_phase = 10∠30° Ω, supplied by a 208 V (line) three-phase system. a) (6 pts) Find phase and line currents (phasors) and per-phase real, reactive, and apparent power. b) (6 pts) If one phase goes open (unbalanced), describe qualitatively what happens to neutral current and load voltages. b) (6 pts) Derive the transfer function H(s)
Part D — Essay & synthesis (20 pts) Choose one of the two prompts (answer thoroughly, ~300–500 words):
Problem 2 — Transient of RL network (15 pts) An inductor L=50 mH, resistor R=10 Ω, and a 5 V step source are connected in series. At t=0 switch closes. a) (7 pts) Derive i(t) for t≥0. b) (4 pts) Compute the energy stored in the inductor at t = τ (one time constant). c) (4 pts) Numerically evaluate i(t) and stored energy at t=τ. (Show numeric τ.)